Recently aquired a Tempest after many years of hunting. Was a project that had been sat for many years.
I have rebuilt the AR2, Power brick, trannys on the monitor cage, High voltage pcb, Deflection board along with a LV2000 and gave the neck a re cap. After some final tests and checks of voltages I fired up the pcbs using a scope first and then the monitor. Much to my relief its all good with no fuses popping, bar a few roms that needed cleaning and the edge adapters its all running nice now.
However I seem to have an issue with the green on the screen. I've tried adjusting the two green pots on the neckboard and unless I turn the brightness up I cant see the green vectors. Any thoughts on where to start?
I have rebuilt the AR2, Power brick, trannys on the monitor cage, High voltage pcb, Deflection board along with a LV2000 and gave the neck a re cap. After some final tests and checks of voltages I fired up the pcbs using a scope first and then the monitor. Much to my relief its all good with no fuses popping, bar a few roms that needed cleaning and the edge adapters its all running nice now.
However I seem to have an issue with the green on the screen. I've tried adjusting the two green pots on the neckboard and unless I turn the brightness up I cant see the green vectors. Any thoughts on where to start?