Back panel replacement

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,085CR
I'm trying to repair/restore a cheap(ish) Lordsvale JAMMA cab I picked up off ebay, that appears to have been dropped on it's back at some point.
smiley18.gif
The MDF monitor frame is broken but silverfox is kindly sorting me out with a replacement.
smiley20.gif
Also, the panel above the back door is broken and will need replacing. Just not sure how to go about it, really. As well as having an angled edge, it has the 2 vents/ hand grips. Can these holes be cut with a router? If so, how? Sorry, I'm a bit clueless when it comes to this kind of thing.

Cheers

PICT0098.JPG


PICT0099.JPG


big10p2015-09-14 16:27:18
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,085CR
I see. I guess I could just turn over the piece with the hole in and use it as a guide for the other side. Don't think I'll be able to cut the angled edge, though. Would need a special saw for that, I guess.

Cheers
 
Top