Hi all,
Got a Battlezone PCB that isn't drawing vectors correctly. I've disconnected the Aux board and thrown it into test and get the below:
I've quickly tried swapping the DACs, LM319 and TL082 in the output section as they were socketed but no change in x/y direction. Also checked the monitor in an asteroids cab and this definitely isn't a monitor issue.
Any ideas on where to look first? Is this likely an issue in the output section or somewhere else?
Thanks,
James
1bradders2022-08-30 17:41:12
Got a Battlezone PCB that isn't drawing vectors correctly. I've disconnected the Aux board and thrown it into test and get the below:
I've quickly tried swapping the DACs, LM319 and TL082 in the output section as they were socketed but no change in x/y direction. Also checked the monitor in an asteroids cab and this definitely isn't a monitor issue.
Any ideas on where to look first? Is this likely an issue in the output section or somewhere else?
Thanks,
James
1bradders2022-08-30 17:41:12