Battlezone PCB Issue

aeroflott

A different league
Feedback
16 (100%)
Credits
1,065CR
Hello chaps.

I've been testing out a supposedly working Battlezone board for another forum member here, and it seems to be running, but with a few issues and I wonder if anyone can give me some pointers as to what might be up.

PCB is getting a solid +5, all chips have been reseated, and inter connecting loom unplugged and reconnected. I've replicated the same issues using another monitor, confirmed working in an Asteroids. So I'm guessing this is a PCB issue.

Firstly, the vectors seem extended and distorted. The extent of this seemed to vary minute by minute, but to give you an idea:

28430917239_cf435c2e45_z.jpg


39499234904_6fbec81de1_z.jpg


26338018038_ea9c9f10f8_z.jpg


39312909915_d7d50b334b_z.jpg


In addition, there were random vectors flickering on screen during gameplay.

That was yesterday.

Today I've switched on, and the distorted vectors don't seem to be there any more (the words and numbers seem aligned OK now, but I'm still getting these flickering random vectors. Here's a vid of what's going on:


If you watch closely you can see them appear every now and then.

Also, in attract mode, I can very faintly hear the radar "blip" when it appears on screen showing the game. (This might be normal for these boards?).

I was thinking about the interconnect cable, as this always causes problems on my Tempest. Maybe a reflow of the header pins might be in order (although it looks as though this has been done at some point).

Any pointers appreciated.

Tony
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
Does TEST report any issues?

I’ve seen bad bit slicers, vector ROMs and RAM produce similar results.Equites2018-02-13 22:18:43
 

aeroflott

A different league
Feedback
16 (100%)
Credits
1,065CR
Smarty you tease.
smiley2.gif


Took a look again at this today. The Vectors now seem to be OK, but the random flickering is still there.

Test mode comes up as a pass and all is fine.
 
Top