Bench Testing Pole Position

rogerxy

Newbie
Credits
2CR
Greetings

I want to bench test my Pole Position pcb(s).

Do I need anything more than +5V/GND for both cards and RGB/Sync to get it to boot?

Thank you
 

smarty

Ready Player One
vacBacker
Feedback
12 (100%)
Credits
1,305CR
Yes that’s all you need. I use a PC power supply connected to the 5v and ground tags on both CPU and video board, then RGBSync wires to the small edge connector, you might want to add the test switch to your rig as well for basic testing.
 

DanP

Administrator
Staff member
vacBacker
Feedback
5 (100%)
Credits
2,232CR
Couple of points. You didn't mention wether it was Namco or Atari PCB's you want to bench test. In my (limited) experience the Namco ones need a more powerful supply than the Atari ones. For example, my 16A supply will run the Atari stack but it will not run the Namco ones, I have to use another more powerful one for those.

It's another point to note that your average Jamma PSU won't be able to run either PP board stack they are just too power hungry. Ideally get something at least 20A on the 5v line.

I'd also suggest using some heavier gauge wire and try to run it to several points on each stack, don't just run one to the edge connector or you'll find variable voltage levels across the boards (and weird problems) and possible heat issues on the connector. For the Atari ones there are some handy test point lugs for 5v and GND that you can use for this purpose.

HTH

Dan
 
Top