Broken Trace Wire

tronads

Active member
Feedback
5 (100%)
Credits
453CR
Depends on the trace really....Kynar for thin tracks, but something slightly thcker if its something like ground or power carrying track.
Kynar is great for fitting mod chips etc, but I cant imagine it would be too good for carrying 10amps etc.
 

drevans

Newbie
Credits
14CR
I'm ordering a new soldering tip for Farnell and need a few more £s to be able to complete the order.

I want wire to fix traces of typical sizes. If I need a couple of types that's fine. Unfortunately they look they they only do massive lengths of 100m. What diameter are we talking for different PCB fixes?
 

obcd

Active member
Credits
3,830CR
For digital signals between chips kynar wire might indeed be what you need. It's also called

"wire wrap" wire. Just make sure you don't order some that looks like wire they use to make coils and transformers. You need some from which you can easily remove the insulation.

For power signals that drive current, you might use something bigger. You could go to a local store and buy a couple of meters of flexible network cable. You could get the wires out of that.

Another place you might be able to buy a couple of meters (with a bigger section) is at your garage. They usually have some for extra cabling in a car.

It's hard to say how big the section needs to be. If you only need to bridge a small gap with a short piece of wire, a small section simply might work fine. If you need half a meter to connect a 5V power signal from one end of the pcb to the other, you will need a bigger section.

It might help if you could show a picture of the traces you need to repair to see what section is needed. If the pcb tracks need to carry a bigger current, they usually are larger as well.
 

drevans

Newbie
Credits
14CR
There wasn't a specific fix I'm looking at obcd, so can't show you anything.

As I was making an order from Farnell and knew I needed some wire to be able t fix this type of thing thought I'd enquire as to what everyone used.
 

vib_ribbon

Active member
Feedback
5 (100%)
Credits
488CR
you dont actually need that much kynar wire. i only have a very small spool and i hardly use it (only on those konami boards where i keep lifting the traces!).

thicker, 18-22awg wire i use a lot more, for making adapters mainly and also general purpose (eg. ikari rotary cables etc). i have a huge box of the stuff in like 10 different colours when one of the firms, farnell or RS, did a special deal on them... enough for a life time, i think.
 
Top