Capacitor ID

tonyg64

Newbie
Credits
22CR
Hi im going through the boards on my Taito SI looking for obvious caps that are in need of changing but cant find what the nunbers on the caps refer to.
one cap is a green squarish shape (theres loads of them) with the number 1H 104k NTK

the other a little round redish one has +22 and + 15 on it.

Can anyone tell me where I can get these or equivilents please?

Cheers

Tony
 

tonyg64

Newbie
Credits
22CR
Also i was practicing desoldering on a modern pcb from a random source and it has a few WIMA mks 3 0.1 (micro farads). its a red square shape. can i fit this to my board?

Cheers

Tony
 

Battlezone

Active member
Feedback
1 (100%)
Credits
410CR
Ok so the red ones do sound like a high capacity tantalum bead
capacitors (Taito SI does appear to have quite a few of these on the
game boards based a scuffy set of schematics I can see)
You won't want to replace them with a random red cap of the
wrong value.
smiley1.gif


The '+' is indicating which pin is positive and
if there is just one number I'd expect it to be the
capacitance in uF for a cap like that (more modern
caps of this sort usually indicate max voltage too).

So it sounds they are 22uF and 15uF and they need to be
connect the correct way around.

You should probably find a set of schematics online and identify
them by their position on the boards.
Battlezone2016-11-23 13:27:08
 

tonyg64

Newbie
Credits
22CR
Ive got about all the schematics you can get online and tbh ive spent ages trying to decipher them but Im blind to it all Im afraid. The cap with the + on it has it written like this

+22

+15

one above the other with no V like some other do.

I have seen + used for polarity but this seems different?

On another one there is 2.2 then 35v so that googles easily .

Cheers

Tony
 

Battlezone

Active member
Feedback
1 (100%)
Credits
410CR
+22 just means 22uF with the positive pin on the left of the labelled side.

My SI (Midway upright, L-shaped board set) is littered with these tantalum

bead caps. You'll see that the pin nearest the '+' on the label

goes to a hole in the PCB that is often also labelled '+'. The one in the

middle of this picture for example is 10uF (25V) with +ve on the right.

Which Taito board set do you have (L-shaped? 3 board set?) and

which caps, on which board, are in question?

IMG_2271.JPG
 

tonyg64

Newbie
Credits
22CR
Thanks John, The one you show that has 22+ then the voltage is ok for me to understand but on my board it has similar green ones and the +22 and + 15 are on the same cap. No V for voltage.
Mine is Taito L shaped 2 board set.

The actual cap that is blown on mine is on another thread here, I'll dig the link out and post it here. As I cant see any markings on this one and its the only red one in a sea of green ones I cant take the chance on assuming its the same as the green ones, but happy to be told it is lol

Cheers

Tony
 
Top