Chihiro Baseboard Tech

retrorepair

Active member
vacBacker
Feedback
26 (93%)
Credits
378CR
Does anyone know what protocol the Chihiro baseboard outputs to the motherboard over GAME 1/2 and GAME3/4? MAMEdev seem to recon it's USB but don't really go beyond that. Does it output as an Xbox controller or HID or something else?

Also does the LPC port have anything to do with controls?

Lastly there's a few jumpers on the top of the baseboard which MAMEDev seem to think are connected to the USB controller, any info on what they do?

retrorepair2013-08-05 13:10:15
 

retrorepair

Active member
vacBacker
Feedback
26 (93%)
Credits
378CR
Ok so a tiny update to this, there are USB headers on the Chihiro baseboard so I added one to see if it came up in windows but no joy, not even as an unrecognised device. It should work really as it does indeed have a USB controller on board and the xbox ports are USB 1.1

I'm beginning to think it needs to see a valid media board and chihiro motherboard to even boot up. That does seem like a pretty wild setup though.

For the record, the Chihiro doesn't use xbox game ports 1/2 at all, only 3/4. If this port is disconnected, the Chihiro will boot but the screen will be a scrambled mess. Same if you connect an xbox gamepad (or two) to this port.

The LPC port and IDE both go directly to the media board btw. The headers on the baseboard just port them right through with no additional processing. So they have nothing to do with the JVS or USB controller.

One cool thing is if you have a VGA BIOS installed (something like FrostyTheSnowman's Evox M8+ VGA Patcher) then potentially you can get VGA from an xbox with the baseboard as it has a LM1881 sync stripper and other circuitry to do it. You just need to connect your xbox to a HDTV with component cables, enable progressive scan in the MS dash then hook up the baseboard. This is all theory but should work fine.

retrorepair2014-02-15 15:24:30
 
Top