Chihiro Caps

FinalFight

Active member
vacBacker
Feedback
73 (97%)
Credits
770CR
I have stripped down my chihiros to give them a good clean and replace the fans.. I have heard a few times about removing the goldcap? Can anyone point me to the location or a link about it .. thanks :)stegrey2017-07-22 19:29:09
 

obcd

Active member
Credits
3,830CR
The goldcap is at location G7. On the edge of the board, you will have letter markings vertically and numbers horizontally. They divide the board in smaller squares. So, basically if you hold the board in front of you, it's on the left front corner. On my board it's C7G10 but yours might be a different revision. It's a 2.5V 1 farad capacitor.
 

FinalFight

Active member
vacBacker
Feedback
73 (97%)
Credits
770CR
obcd said:
The goldcap is at location G7. On the edge of the board, you will have letter markings vertically and numbers horizontally. They divide the board in smaller squares. So, basically if you hold the board in front of you, it's on the left front corner. On my board it's C7G10 but yours might be a different revision. It's a 2.5V 1 farad capacitor.

Thank you .. why are they removed? Is there any others i need to check?
 

obcd

Active member
Credits
3,830CR
After some years, the goldcap bursts open and starts leaking. The stuff that comes out of it is corrosive and eats the surrounding pcb traces and solderings. (They oxidate) After a while, the pcb becomes damaged. Sometimes, the capacitors surrounding the Cpu (in front of the heatsink) become bad as well. If the top plate isn't flat, they are bad, but not all capacitors show that they are bad like that. Sometimes the bottom rubber is pushed out and the capacitor is no longer having a 90 degree angle. Problems with those capacitors usually result in a non booting system. It's also possible that the system freezes after a while.
 

obcd

Active member
Credits
3,830CR
The 1 farad 2.5V capacitor (goldcap) was used in the original xbox to keep the real time clock going when the console was disconnected from the mains. The chihiro has a separate real time clock on it's base board that can run several months on the CR2032 coin cell mounted on that board.

Have you checked if your nvidia MCPX chip is the MCPXII or MCPXIII? Is your gpu really having the larger heatsink without small fan?
 

FinalFight

Active member
vacBacker
Feedback
73 (97%)
Credits
770CR
Sorry when i mentioned the gpu with no fan on the other thread i meant my original xbox consoles.. my goldcap looks fine .. but i am best removing it anyway? :)
 

obcd

Active member
Credits
3,830CR
You might as well remove it while the system is open. You can melt the solder on one of it's pins and slightly bend it over in the direction of the other pin so that the pin comes a little out of it's hole. Next, you do the same with the other pin and bend it back. After a couple of times like that, one of the pin's should become loose from the pcb. Now you can melt the solder on the still fixed pin and pull it out of the pcb. Just don't use to much force and use a good soldering iron. The holes will still be filled with solder after the removal, but since you don't need to install another capacitor, it doesn't matter.
 
Top