Chip request

biglouie

Active member
vacBacker
Credits
84CR
Evening...

Because I am an eejit with fat fingers, I pulled a chip in my Galaga midway board and snapped a few pins. This was obviously going to happen as my house was hit my lightening last week and my car alarm gave out on Monday. So I expected issues..

I wondered how I go about locating a new chip and if anyone could help?

It's the galaga midway chip from 1C on the video side, seems to say 7611 on it.

Ill try not to inject myself with the pins when I get a replacement. That hurts a bit, I have found..

Thanking you in advance!

Best

Rob

IMG_20170725_215423_01_01.jpg
biglouie2017-07-25 22:11:55
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
It's a Bipolar PROM, is there any part of the pin(s) left to solder to? If so you could put it in a turned pin socket and solder it in using wire / cap leads on the missing pins.
 

biglouie

Active member
vacBacker
Credits
84CR
One pin came off, not much of it left at the top but I could give it a go. I've still got the bit of pin that fell off.. The hypodermic needle bit!
IMG_20170725_221646_01.jpg
 
Top