Cleaning Solder (Literally)

joe34

Active member
Credits
448CR
hey all,

a good friend gave me a reel of solder recently (pictured below), he got quite a lot of reels from his old company when it closed down ages ago

the problem is, they weren't stored very well, so i noticed when using it today for the first time, there's a smell of, it seems like 'burning oil' when the solder is melted

i then stopped what i was doing and cut off a piece of solder from the reel, and pulled it through some tissue paper with some pressure ... then after, i looked at the tissue and it had black lines of dirt/oil which the solder had left behind

it's an unused full reel of solder, seems a shame to throw it away, can it be cleaned? im more than happy to unravel the entire reel in order to clean (i dont care about afterwards having it on a reel or not).

dont suppose anyone has any ideas about cleaning the solder, eg. hot water (boiling?), or foam cleanser, something like that? i do have iso alcohol here also..

cheers!

solderr.jpg


joe342015-10-08 19:42:31
 

obcd

Active member
Credits
3,830CR
Simply wiping it clean with a piece of tissue just before you use it could be the way to do things.

You just have to wipe like 10 inches, the piece you think you will maximum need.

The fumes could come from the flux that is embedded in the solder wire.

If it became dirty during storage, you would expect that only the outer windings need cleaning, the inner ones are covered by the outer windings.
 

joe34

Active member
Credits
448CR
ah thanks guys ok, i wont worry about it then and just use it (but give it a bit of a wipe with tissue before i use it.. at least for the start (outer) of the reel anyway).

ps.. and i will watch those fumes.. feck me they are intense
smiley15.gif
smiley36.gif
 
Top