Coin mechs.

cliff_poole

Active member
vacBacker
Feedback
6 (100%)
Credits
1,069CR
I am new to coin mechs and have just picked up a Sentinel 195 and
credit board to go in my cab. It plugs straight in but didn't work so I
disconnected the credit board and wired up the 0V and +12V on the mech
directly to my bench power supply. Should this be enough to test it or am I
missing something ?, all the coins still fall directly through the reject
slot.

Thanks,

Cliff.

__._,_.___
Messages in this topic (1) Reply (via web post) | Start a new topic
 

cliff_poole

Active member
vacBacker
Feedback
6 (100%)
Credits
1,069CR
Craig,

Many thanks, you have saved me a lot messing about. Taking the
casing off the credit board I can now see that it probably does a lot more
than I originally thought.

Cliff.
 

Swallow

User
Credits
29CR
In message <003301c6ad99$5bef78a0$6501a8c0@orac>, Cliff Poole
<clifford.poole@ntlworld.com> writes

Hi,

All the common coin mech pin outs can be found here:;

http://www.coin.demon.co.uk/parts/c00084.htm

You may find these useful.

Regards,
Steve.

> I am new to coin mechs and have just picked up a Sentinel 195 and
>credit board to go in my cab. It plugs straight in but didn't work so I
>disconnected the credit board and wired up the 0V and &#43;12V on the mech
>directly to my bench power supply. Should this be enough to test it or am I
>missing something ?, all the coins still fall directly through the reject
>slot.
>
>Thanks,
>
> Cliff.
>
>
>
>
>
 
Top