Corrupt graphics

ruggy

Newbie
Credits
3CR
Hi,

I have a Salamnder jamma board but some of the graphics are corrupt and the corruption destroys the player ship if touched. I wondered if there is anything I can do to fix it?

Thanks.
 

bones

Active member
Feedback
15 (100%)
Credits
1,628CR
I'm not familiar with this PCB but the first thing to do is to get a small flat blade screw driver and slightly lift all the chips in sockets and press them back down in place(reseating). I've had many konami PCBs that suffered graphic glitches because of the chips legs oxidizing,sometimes when the legs are quite black I've had to chip it off gently with a Stanley blade or a very fine grit nail file block lol. It could be a multitude of things causing it right up to a bad chip or 2 . But if it has been working for you ok before it may be something simple. I'd reseat the chips first, secondly it could be a bad socket(oxidisation) you could gentle press down on the eproms one at a time supporting the PCB from underneath with bit of polystyrene or rubber and see if that changes anything. There's a chance your 5v may be too low,it might read 5v at the edge connector but at the chip it might only be 4.7v. NB it should never be above 5.25v that can start frying them. I'd guess your problem is hopefully just one of the first 2 things I mentioned. bones2022-09-15 19:04:06
 
Top