Cruisin World help!

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
Hi all and I hope you are having a good break!

I was just after some tips with apparent board fault and monitor issue.

I have a new PSU but struggling to get the board to boot..it either makes 1 or 10 bongs on start up and it's very hard to get the right voltage for 2 bongs! I do have some spare boards to try.

Also seller tells me the screen does not have a demagnetiser [although it appears there are magnets bound to some of the cabling near / from the monitor. I think I have to buy a magnet from ebay...any tips? Thanks in advance

Paul
 

gunblade

Active member
vacBacker
Feedback
23 (100%)
Credits
9,116CR
demag is done via the degauss coil, that surrounds the tube itself - post some photos of the back of the tube and the chassis itself.
I doubt there are any magnets on the cabling, they are most likely feritte cores which are sometimes added to reduce interference - you see these on usa built machines and it was something to do with federal laws about radio interference

you have a multimeter to check the voltages when setting up the power supply?
 
Top