Daytona problem

Rockstar

Newbie
Feedback
1 (100%)
Credits
2CR
Just bought a Daytona 2 from Stegrey. Left machine seems to have poor picture quality although when the script comes up it's clear it's just the actual game play is fuzzy. Any ideas and please don't tell me it's a graphics fault
 

Outrun2

Colonel Outrun
Feedback
5 (100%)
Credits
1,182CR
Anything can happen in transit - any number of things can come loose especially old electronic components.

From your initial one liner it sounds like a gra..

Get some pics up
smiley1.gif
 

Outrun2

Colonel Outrun
Feedback
5 (100%)
Credits
1,182CR
You can swap stuff around but I'd get get some pics up first - no point swapping stuff over yet until you've narrowed down the fault. It's not a 2 minute job swapping a video board in a Model 3 stack!
 

FinalFight

Active member
vacBacker
Feedback
73 (97%)
Credits
770CR
i will try get some pics up.. the cab was working fine before it was picked up i did a video to show it working so somethings only happened during transit :s
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Don't swop the video pcb around as that's more than likely going to cause damage as you need to be very careful not to bend the pcbs.

Once pics are up people can give you more information.
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Sorry to say but that looks like a video board fault. If it was monitor then surely the blue writing would also look fuzzy. I could be wrong so we what others say.

Good luck.
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,091CR
It does definitely look like a board fault, rather than monitor. Having just been transported, the first thing I'd do is make sure all connectors are seated properly.
 

seanr28

Active member
Feedback
9 (100%)
Credits
319CR
Best thing to do, would be to remove the board stack carefully, strip it, clean with air gently and reassemble, Ive had a few that have worked after doing this, usually when the video board goes on the step 2 you just get polygons and lines, this is more likely a video Ram issue and therefore much easier to repair.
 

Rockstar

Newbie
Feedback
1 (100%)
Credits
2CR
Wiring is pretty bad on the machine will be redoing a lot of it. In the working side that main box wasn't even screwed in and all the Earth wires are disconnected. All the graphics faults I found where the car flying about etcbut this is just fuzzy I can still play the game fine just really bad picture quality.
 

Outrun2

Colonel Outrun
Feedback
5 (100%)
Credits
1,182CR
This is what happened to one of mine and it ended up being the video board..

37118059156_41a89a88cf_c.jpg


Worth spending some time cleaning the boardset though as you never know, they can spring back into life. Try swapping the ROM board over as well and making sure the chips are pressed in firmly.
 
Top