Decasing TV

Feedback
1 (100%)
Credits
39CR
I have a Bang and Olusfen MX7000 TV. Due to these TVs being very shallow in depth I reckon it would physically fit in my cab. My question is, are these TVs easy to work with decased, would I need to make a mounting frame to locate the various boards, what are the risks or things to note when doing this?
 

andrew96

Unfixable? What's that word mean?
Feedback
1 (100%)
Credits
899CR
Yeah there the 110 deg tubes, B and O great while they work, bugger when they fail, was always near impossible to fix, but they drove the Philips tube very well much better than Philips did as the tubes last! If I remember right don't think you could get circuits for them back then, might be different now with tinternet
 
Feedback
1 (100%)
Credits
39CR
Without the casing do the circuits 'flop' about, or are they mounted within the casing as oppose to in some form of frame?

Don't wanna take it apart until I know what I'm dealing with!
 

bbz149

Active member
vacBacker
Feedback
26 (100%)
Credits
1,608CR
smiley3.gif
Nooooo! it's a B&O don't kill it
smiley36.gif
Rem paying 1k for a new one of these BITD
 

GameOn

Active member
Credits
133CR
I would recommend an ex hotel TV as they are a lot easier to auto power on and autoswitch to RGB AV then generic TVs do, they do appear on Ebay every so often. They also tend to be used less then normal TVs as a lot of the time they were off.

Most TVs will have the electronics as part of the lower plastic frame, if you are good at wood working or plastic then it's easy enough to make a board that will fit into. The B&Os are a couple of fiddily separate boards so would require some work but is not impossible.
 
Top