Diodes?

obcd

Active member
Credits
3,830CR
I assume you know that desinfection alcohol is the preferred product to clean a pinball playfield. It removes the black rubber particles without damaging the paint. (Still better test it on an invisible corner to be sure.) After that, you can wax the playfield with some special pinball playfield wax. It ensures that the playflield stays proper for a longer period. Suzo Happ used to sell some rubber kit's for pinballs containing most of the common length, but maybe you already have a place that sells those. Enjoy your restoration.
 

Ronnie Dent

Active member
vacBacker
Feedback
15 (100%)
Credits
1,206CR
Thank you for the advice, I have some alcohol cleaner I use for pcb cleaning of flux etc isopropanol?

Luckily I have a large selection of rubbers I got from an operator from who I bought his last pinball a few years back. hope to make a start on the playfield when the psu is running correctly

Ronnie
 

Ronnie Dent

Active member
vacBacker
Feedback
15 (100%)
Credits
1,206CR

obcd

Active member
Credits
3,830CR
As long as the holes in the pcb are big enough to fit the wires of those new diodes, you are fine. If not, you could drill them a little bigger if there only are tracks on one site of the pcb. If it's a dual layer, there could be via's in the holes connecting tracks from the solder site to tracks of the component site. If you can solder the zener wire on both sites, you can drill out the vias on those as well.
 

Ronnie Dent

Active member
vacBacker
Feedback
15 (100%)
Credits
1,206CR
obcd said:
As long as the holes in the pcb are big enough to fit the wires of those new diodes, you are fine. If not, you could drill them a little bigger if there only are tracks on one site of the pcb. If it's a dual layer, there could be via's in the holes connecting tracks from the solder site to tracks of the component site. If you can solder the zener wire on both sites, you can drill out the vias on those as well.

Brilliant thanks for confirming that, just need the resistor now!

Also found a capacitor in the 5v that was starting to vent from the base! 330uf 25v but I had some of those which was handy

Thanks Ronnie
 

Ronnie Dent

Active member
vacBacker
Feedback
15 (100%)
Credits
1,206CR
Resistor arrived today so I rebuilt the psu re fitted it, checked voltages they were all good -110 was -109 all the others close to what they should be so hooked up the DMD it is still dead so at least I know it's for sure bad! I pulled the high volts fuse and fitted the pinled and all is good, working nicely.

Just need to strip and clean the playfield and see what bits I need, possibly a couple of targets.

Big thanks to obdc for his valuable advice
smiley20.gif


Thanks Ronnie
 
Top