EEPROM chip reader?

runkthepunk

Active member
Feedback
2 (100%)
Credits
19CR
Hey guys

Sorry not actually arcade related but some of you guys deal with EEPROM chips and know your stuff so thought I'd ask here.

I have a very small chip removed from a DVD player I want to read this chip as I believe the DVD splash screen / startup screen logo will be on here. My end game is wanting to change the DVD screen logo.

Can anyone point me in the right direction for some kind of reader I would require?

This is what the chip looks like:

1564-00.jpg
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
Non-Volatile memory devices that size are usually serial EEPROMs like 93c46, 93c56, 24c08, 95080 etc...

However, not sure it would have enough space to hold a splash screen, and access to these devices is usually slow.

Not sure to be honest.

Equites2016-05-18 16:09:49
 

runkthepunk

Active member
Feedback
2 (100%)
Credits
19CR
Equites said:
Non-Volatile memory devices that size are usually serial EEPROMs like 93c46, 93c56, 24c08, 95080 etc...

However, not sure it would have enough space to hold a splash screen, and access to these devices is usually slow.

Not sure to be honest.

Thanks for the response
smiley1.gif


Hmmm okay thats not what I was hoping. It is very small (the numbers on mine are different to the picture) The pictures states its a 1MB SPi flash memory module.

I just assumed it would contain localisation stuff for the cheapo DVD player so Eng languages and logos that way its easy to install during production?

Mine reads:
Winbond
25D8 OVAIZ (the O could be zero and the I could be a one)
0936

Can you help with what kind of reader i'd need?

runkthepunk2016-05-18 16:22:22
 

ColinD

Active member
Feedback
6 (86%)
Credits
1,367CR
It's ages since I played with DVD players, As far as I know the chip just used to contain the settings for the player like the region zone and macrovision enable / disable etc.... The rest was all in the main Flash or Rom.

There were at the time some tools available for one of the cheap popular players based on a couple of the chipsets at the time (LG, Manhattan Models - They all looked the same) so you could change the logo's and all that via a custom made firmware update CD (iirc).... This is donkeys years ago !!

There was a site called dvdchips and I re-wrote the I2C code back in the day for him ported from a bigger device to run on a cheap pic12c508 (which only had a small stack). The guy used to sell the chips which you wired to the IC2 Bus and it then reprogrammed a few bytes in the memory chip so you could have region and macrovision free players.

Later on he used to send you a 'one time usable' remote transmitter which you could use to zap your player and then return it to him (which worked as either a factory setup remote or just did the required 'secret code' key press sequences I guess)

Sorry, Can't offer much help reading the chip, but if stuck you could probably use an ardiono to read and spit out to the serial port which you could log/record. Will be spi or i2c no doubt !!

https://www.arduino.cc/en/Tutorial/SPIEEPROM - You would have to mod this so it only reads and doesn't write !!

Cheers, Col

ColinD2016-05-18 20:28:30
 
Top