explorer arcade

Credits
20CR
hi everyone i a newbie on here trying to repair a 1983 explorer upright although i have basic knowledge of electronics im a virgin wen it comes to arcade boards this isn’t a jamma pin out the machine boots into garbage a screen of numbers letters and characters all static where do i start lee o callaghan2022-09-19 20:22:47
 

qjuk

Active member
vacBacker
Feedback
51 (98%)
Credits
2,079CR
In addition to what Lurch666 said, also check out the ram chips.

What’s the condition of the board like? Do the sockets look like they are in decent condition?

I would also gently push down on various places on the board whilst it’s powered up to see if there are any changes onscreen.

After that I would be getting out the logic probe.
 
Credits
20CR
BE3EB493-B4CA-4763-954F-B262246A7717.jpeg


heres a photo of the board
 

Lurch666

Active member
Feedback
21 (100%)
Credits
4,507CR
One for sound and one for running the game.

I think it's the one in the top left of your picture that runs the game but just swap them both out one at a time and see if there's any difference.

Do you have a scope or logic probe?
 

ArcadePCB

User
vacBacker
Credits
509CR
I would check the reset signal first. If it doesn't work as it should, the CPU doesn't start running. If it's OK, check the CPU clock next. You need at least a logic probe for doing this. If these signals are ok, check the address bus, especially the lest significant ones. There must be action, otherwise the CPU is not running. Then check the data bus -> if static, the CPU is not running.

If you can't find the problem, you can try changing parts blind (not recommended) or you need more advanced tools - oscilloscope, Fluke 9010A, ....
 
Credits
20CR
thanks all i will try reset line then clock i havnt got a eeprom programmer im a novice to this but all help is very much appreciatedlee o callaghan2022-09-22 20:31:22
 
Top