explorer arcade

favouredson

Super Star
vacBacker
Credits
1,260CR
Lurch666 said:
Just had a chance to check and you CPU does appear to be in the correct orientation.

An honest mistake.

Having found a clear PCB image, I now know that the CPUs are supposed to be inserted differently.

So, on with the repair...
 

Lurch666

Active member
Feedback
21 (100%)
Credits
4,507CR
If pin 6 of the CPU is high then pin 9 of the LS04 should be low.

The LS04 is an inverter meaning a high pin 9 should mean pin 8 should be low and since pin 8 is connected to the CPU then pin 6 of the CPU should also be low.

Check pins 8 and 9 of the LS04 with the CPU removed and see if there's any difference.
 

Lurch666

Active member
Feedback
21 (100%)
Credits
4,507CR
Always worth a try.

Piggy back then check pins 8 and 9 again (unless the game shows any more life of course).

If no difference try piggybacking but with pin 8 not touching and see if there's any difference between the LS04 in the PCB and the one piggybacking.
 

Martinmurphy30

User
vacBacker
Feedback
4 (100%)
Credits
421CR
By no means an expert but my logic probe just emits a high signal and noise when probing a clock signal regardless of settings....which is why I recommended testing of with a Hertz reading multimeter, to be sure!??
 
Top