Filling routed grooves

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
I need to fill in a t moulding groove and re route it, as it is too wide for standard t moulding.

What is the best filler / method to use. I'm thinking of using a caulking gun and squishing it in as best I can then re routing it when hardened. Not sure if wood filler can be re machined though?

Any pointers from someone who may have done it before?
 

Hurray Banana

Moderator
Staff member
vacBacker
Feedback
8 (100%)
Credits
2,756CR
you want something that sets hard and can be drilled something like P38 filler. Wood filler wouldn't work well

Ninja'd by Stryker
smiley1.gif

Hurray Banana2016-11-03 08:51:32
 
G

Guests

Guest
Vic, P38 is all very well and good, but it doesn't like shock. Not sure about you guys but I tap T-molding in with a rubber mallet. You do that on P38 it will most likely crumble or if you had to take the T-molding back off for any reason you may well have a nasty surprise.

I'd use Gripfill or similar from a gun as suggested. It firstly sets 10 times harder than P38, it has greater adhesion and will also put up with some abuse. It will also be a tidier, quicker job.

Good luck.
 

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
Yes! Good 'ol gripfill. I forgot about that old acquaintance. My old house was held together with that stuff!

Screwfix, here I come!

Cheers chaps!
 
G

Guests

Guest
I'm not saying P38 is a big no, no. Just stating there are superior and more reliable alternatives for this particular job.
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
PAC-MAN said:
I'm not saying P38 is a big no, no. Just stating there are superior and more reliable alternatives for this particular job.

A good suggestion Pac-Al!
Proper mastic, like SikaFlex will go very hard but will flex and give a little without coming loose. Making it mallet proof yet cutable with a router bit. Cheap stuff like No-More-Nails and "Sticks Like ****" (their product name, not mine) are cheap alternatives. Sikaflex or HIGH MODULUS MASTIC and it has to be maybe double or treble the price (unless you can get it on a deal) but is what you want.

sika.JPG


I've bonded aluminium to fibreglass body panels and aluminium to steel with the stuff and I'd not touch NoMoreNails with a bargepole.
 
G

Guests

Guest
You're not kidding Rich. I fitted a Stern Thruster to a powerboat going back years ago for a chap. Probably over ten years ago now. I saw him recently, the boat was out of the water during the summer having some work done. The Thruster is still sealed with the same Sikaflex I put on it and it sits under the water permanently.

Awesome stuff!
 

dj_yt

Active member
Feedback
3 (100%)
Credits
787CR
Can you not glue-gun the new T-Molding on if the groove is too big?

I've done this before and it looks great, you avoid hammering your cabinet to death and it's easy to remove if you ever need to in the future.
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
You can use a glue gun yeah if the moulding keeps dropping out and the groove is just a bit sloppy or some T-moulding has gotten broken off and you can't replace it with pukka stuff.

The mastic route is a good suggestion where you've a big chunk missing, especially on a corner that you'd usually use plastic filler on.
 
Top