First repair advice

urbanledge

Active member
Feedback
2 (100%)
Credits
95CR
I'm almost ready to tackle my first pcb repair.
I've a few boards I'd like to try fix but just looking for a small bit of advice.

Out of the boards below what do you think is realistic for starting out?

My test rig isnt 100% ready yet but after plugging them into my jamma cab I have the following

-gallaga 88,does nothing when plugged in.found a missing transistor on the cpu board but(i think) thats in the video out section

-mortal kombat boot that plays blind but found 2 (filter)missing caps

-wc90 bootleg,again seems dead

I haven't probed the dead ones or anything

Any tips would be great.

hoping to have my test rig complete soon

Thanks
 

Selina

Active member
Feedback
2 (100%)
Credits
53CR
without a 100% working test-Station it is "hard" to find the fault. tip: FIRST FIX YOUR TEST STATION! start by 1, not by 17.
smiley2.gif
 

Battlezone

Active member
Feedback
1 (100%)
Credits
410CR
I'd start on the oldest board (once the test rig is going
smiley2.gif
). In general the newer the board the harder they are to fix IMHO (you can easily get bogged down in lots of undocumented custom chips on the newer boards).

I always take a screwdriver and re-seat all the chips in sockets (and inter board connectors) first, I guess this fixes about half my boards when they misbehave.

MK sounds like it might be close but I'd be surprised if a couple of missing filter (decoupling) caps is the problem (unless they are larger electrolytic 'tank' supply caps).

The totally dead ones may be easier to get going than the part working ones. I'd probe the supplies, clocks and the CPU first.
 

Nes4life

Active member
vacBacker
Feedback
12 (100%)
Credits
1,134CR
What tools are you using alongside your test rig? Multimeter (with continuity buzzer) is a must but after a while you may need a logic probe and perhaps an oscilloscope. You got a good soldering iron, solder sucker and reel of solder? Isopropyl and cotton buds are also a must for me as boards are usually dusty so it's hard to see some traces go.
Nes4life2016-03-01 13:03:26
 

urbanledge

Active member
Feedback
2 (100%)
Credits
95CR
I've a good bit of gear.
I've done some stuff before like Lopts,cap kits,change Hots take off ICs and change them but not really fault finding .

Have a DMM,Logic probe,solder station,desolder station and have an Oscope (really old and goes to 20mhz so dont know how much use that will be)
 

backflipper

Active member
Feedback
4 (100%)
Credits
774CR
The 4 main components of every digital circuit is:
- Power supply
- Clock
- Reset
- Busses

Check all of these and you will cover the basics. A DMM and a logic probe can test all of them.
 
Top