I was wondering if anyone has attempted any Fluke pod conversions, and taken any pictures whilst doing the conversion? Specifically I'm interested in the 6800 to 6502 conversion
I've followed the instructions I've found, and am fairly sure I've done everything correctly, and not dug too deep with the trace cuts, however my pod is timing out.
I noticed that the instructions refer to a revision C top board and a revision B bottom board.
Both my boards are revision B's and I'm wondering if that's the problem?
As far as I can tell from looking at the guide pictures and my PCB they are identical in layout/components
Anyone any thoughts?
Purity2016-11-27 21:37:55
I've followed the instructions I've found, and am fairly sure I've done everything correctly, and not dug too deep with the trace cuts, however my pod is timing out.
I noticed that the instructions refer to a revision C top board and a revision B bottom board.
Both my boards are revision B's and I'm wondering if that's the problem?
As far as I can tell from looking at the guide pictures and my PCB they are identical in layout/components
Anyone any thoughts?
Purity2016-11-27 21:37:55