Fluke Pod Conversions

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
I was wondering if anyone has attempted any Fluke pod conversions, and taken any pictures whilst doing the conversion? Specifically I'm interested in the 6800 to 6502 conversion

I've followed the instructions I've found, and am fairly sure I've done everything correctly, and not dug too deep with the trace cuts, however my pod is timing out.

I noticed that the instructions refer to a revision C top board and a revision B bottom board.

Both my boards are revision B's and I'm wondering if that's the problem?

As far as I can tell from looking at the guide pictures and my PCB they are identical in layout/components

Anyone any thoughts?
Purity2016-11-27 21:37:55
 

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
There were two issues:

1 U8 (P9) needed to be connected to +5V and not to U11 (P13) from which it was
cut.

2. A jumper was required from U8 (P11) to U12 (P2). Without this
jumper the pod cannot change data directions in U1 of the Interface board
and will fail a self test. This was my main issue

Purity2017-02-14 16:36:29
 
Top