Flyback Replacement Fitting

DABYX

User
Credits
109CR
Hi chaps,

Currently replacing the flyback on an Electrohome g07 and whilst I can get the pins in place with slight bending, once tightening it with the screws to the chassis, it becomes a problem with flexing etc.

I found a post on the system 11 blog about this so have bolted it to the chassis first then soldered it in but curious about it not sitting flush to the pcb now.

Am I safe to turn the thing on, could there be a possibility of damage, shorts across pins etc.

Cheers,

Mike
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,578CR
Don't worry, it'll be fine. None of the replacements sit flush, I think their pin position template must be slightly off! I've fitted quite a few of the repro G07 flybacks and they've all worked no problem.
 

DABYX

User
Credits
109CR
Whew! Good to hear. :) really wanted to make sure it was bolted correctly to reduce vibration as beforehand it was screaming like an 80s horror!

Cheers tb2000 :)
Now to pluck up courage to try the sob
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,578CR
Yep, just obviously make sure you've not got any solder splashes bridging the pads where the pins solder to, apart from that you should be ok. Are you sure it was the flyback that was noisy? Usually it's the linearity coil that make a screaming noise on most chassis!
 

DABYX

User
Credits
109CR
No not sure what it was and was too nervous about poking around when it was on.
So uh, whats the linearity coil?
smiley9.gif

The width coil?

Edit: yep still singing but no explosions!
smiley20.gif

DABYX2016-01-31 15:48:53
 
Top