G07 explodes

monty

Active member
Feedback
6 (100%)
Credits
39CR
.. I recently fixed a dead G07 CB0. Replace Flyback, HOT, new caps etc... monitor fixed and working great..

A couple of hours later the flyback explodes. Usual large crack on side with back goo.

Any idea what would cause a brand new (Bob Roberts type) flyback to die after only a few hours of use. I've ordered another, but a little concerned something on the chassis will cause the next new one to blow too. Wonder if this is a bad batch or caused by the G07 chassis?

Any thought appreciated.monty2014-11-30 12:13:50
 

monty

Active member
Feedback
6 (100%)
Credits
39CR
It didn't blow the small fuse, not until it was switched on for the second time after the initial bang.monty2014-11-30 12:52:08
 

gunblade

Active member
vacBacker
Feedback
23 (100%)
Credits
9,116CR
no its just a bad flyback,possible manufacture fault-one off i would imagine
obviously double check the b+ but that should not cause that issue anyway
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
I heard on the arcade outsiders podcast that bob Roberts has had a few problems with the odd dodgy flyback.

Hope you get it sorted.

Steve
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Not sure if he knows about them but the guy from johns arcade said he had had the odd problem with them.
I didn't think bob Roberts posted to the uk?
I could do with a few spare from him but I am sure I asked on here before and was told he didn't post to the uk.

Cheers
Steve
 
Top