G07 Horizontal Width issue

tronads

Active member
Feedback
5 (100%)
Credits
455CR
Plea for advice from the monitor experts out there....

I have one final issue with the Electrohome G07 19" monitor in my centipede which is really "bugging" me.
I got the cab playing blind, and basically shotgunned the chassis, gave it a full cap kit and fitted a new flyback to it and replaced the blown fuse with a socketed new fuse, which brought it back to life, with really quite a nice picture, despite a little screen burn.

A problem still existed with it though, in that adjusting the Horizontal Width coil did absolutely nothing, and I have about an inch at the top and bottom of the screen unused. The coil had black goo on the outside of it, so I presumed it was dud and ordered a new one.

This week I got sick of a dry joint that was causing the sync to go if the fire button was pressed a little too aggressively, so I whipped out the chassis and sorted that (it was on the video input connector pins) , so while it was out I fitted the new width coil.

Now its all back in, I find that the new width coil still makes no adjustment whatsoever, and worse still, I have lost a further 1/4 inch of screen use top and bottom. This means that I now actually see some screen burn when playing, which is annoying.

Any ideas what I should be looking at when I next remove the monitor from the cab ?
 

patzik

Active member
Feedback
1 (100%)
Credits
388CR
Was just typing the cap thing and then looked at the website above, well this about sums it up
smiley1.gif
 

tronads

Active member
Feedback
5 (100%)
Credits
455CR
Seems like an easy fix, just find a value that fills my screen. I will get a variety orderd and have a go at that next time I have the urge to remove the monitor.
Doesn't help me understand why my new width coil is doing nowt though. Waste of $12 that was !
 
Top