G07 no b+

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
I have just taken a look at my go7 in my defender cab.
No neck glo or b+ voltage at the big white resistor.

I have power coming into the monitor at just over 120v but on testing the b+ nothing!!!

The chassis was re capped a few months ago and a new lopt fitted. It's had about 6 hours use then it just died on me.

Any idea where to look now? I have searched the net and most posts are about adjusting b+ or saying it could be the resistor or lopt. I'm hoping it's not the lopt as its nearly new. Also fuses check out ok .

Any ideas please?
bonehead2016-07-20 22:10:43
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Ok slight update.

Checked r902 long White wirewound resistor and it tests open.
Any idea of the value as it seems to be 7w 2k ohms. Would that seem correct? Manual lists it with different value.

If I can identify correct value I will buy one and try to see if it fixes the monitor.

Thanks

I think it could be 7w 2ohms wire wound resistor. Marlins have 7w 2.2ohms, would that be OK to use?

Thanks again.

bonehead2016-07-20 23:14:11
 

funhouse

Active member
vacBacker
Feedback
3 (100%)
Credits
362CR
Here's a photo of the one on a chassis I have.

902resistor.jpg


The part list says it is R1902 wirewound 2R0 7W 10%

The text above makes it look like a 220k ohm resistor - I'm sure there are others on here who know more about its spec.

So maybe you are correct that it is incorrect, but perhaps 2RO is somehow a reference not described in the manual?

Anyway, if you can source a similar component (suitable for 7W or more??) then it should work.

funhouse2016-07-21 19:30:56
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Ok thanks. I think the one in your picture is r901 and not r902. I'm sure the one I need is very similar but underneath that one on the chasiss.

Thanks
 

funhouse

Active member
vacBacker
Feedback
3 (100%)
Credits
362CR
Showed my newbie credentials there lol.

Okay, well 2ohmsK and 7W is what mine has written on it.

In circuit I read 2 ohms across it and the other one I mentioned above reads 220 ohms. It could imply then that the K is nothing to do with thousands on these resistors.

Personally if I read the resistor as open like you, I would probably try a replacement at 2ohms 7w.

funhouse2016-07-22 13:41:34
 

RSwanson

User
Feedback
1 (100%)
Credits
205CR
It may have just failed due to the numerous heating and cooling over the years, but are you sure it wasn't due to failure of the bridge rectifier? I'd check that before replacing the resistor.
 
Top