Genie 2000 - Graphical Issue

neoretro

Active member
Feedback
11 (100%)
Credits
1,121CR
Hi,

Picked up a Genie 2000 game board off of eBay. It's arrived and seems to have a graphical glitch. The guy is reluctant to take it back as he has pictures of it working fine before sending.

I want to try and fix it to save a load of aggro. The screen appears fine and sound is ok but there are random constant red lines appearing all over the screen about 1cm long going horizontally. I've attached a picture.

Any ideas at all?

Thanks
IMG_4127.PNG
 

Flinnster

The Dino King
vacBacker
Feedback
29 (100%)
Credits
2,566CR
Try measuring the 5v voltage line at the board edge. Sometimes low voltage can cause this kind of thing, you might need to slowly raise the voltage on your switching PSU and then re-power up and see if they go. Don't go crazy high however, stop if things are getting hot.
 

neoretro

Active member
Feedback
11 (100%)
Credits
1,121CR
Cheers.

I'm running a supergun and the PSU is enclosed within.

Not even sure the functionality to incrementally up the voltage is available? Would that affect my other games if I did this as this is the only one that has the issue?
 

Flinnster

The Dino King
vacBacker
Feedback
29 (100%)
Credits
2,566CR
Yeah probably best to not fiddle then if it's all encased
smiley5.gif
Unfortunately some game boards are more picky on voltage than others, bigger boards suck more voltage too. If you have a multimeter, you can still check the 5v pin on the edge of the game board though - may throw some clues.
I presume Genie 2000 is a pretty small single layer board?

Do you have any socketed chips on the board? May be worth trying to carefully re-seat them and then try re-booting. Failing that maybe try to get this tested on someones cab where they can look at voltages more easily.
 

penrhos

Active member
Feedback
23 (100%)
Credits
747CR
If you have a voltage meter check the 5v at the edge connector - on the Pana there's a hole halfway down the back where you can adjust the voltage using a flat blade screwdriver. Just don't turn the voltage up too far in case you fry the pcb - 5.10 should be safe.
 
Top