Glass Glue

DABYX

User
Credits
109CR
HHi guys and gals,

Just got our first cab and it's an oddity for sure! Not worth much to anyone but we love it.

It has a glass bezel with some flaking which I'll probably clear with krylon or something eventually.
However there is a large chunk broken in the bottom corner that's currently taped in place.

Ideally we want to keep this glass, even if it's worse for wear so have been looking around at glass glues.

UV curable ones seem the ticket but I've never used anything of the sort.

Anyone have recommendations or ideas?

Cheers!
 

69er

Active member
Feedback
6 (100%)
Credits
1,848CR
put up a picture of the glass or whole cabinet i am sure someone will possibly have a decent alternative especially if you include the dimentions of the glass

but back to your question i have used UV curable glass glues quite successfully in the past but do benefit from a greenhouse which speeds curing a bit

done a pinball backglass which was in about 10 pieces and it lasted out on site for about 2 extra years , just as a fail safe i sort of laminated it on the face side with a 0.8mm perspex just in case it gave way but it never did ......once did an asteroid top marquee just in two bits 90%/10% and it held till i got rid of the game about 3 months later never saw it again so not sure how long that lasted...... and i have also done a couple of other repairs .. just dont depend on the resultant strength as the joint will always be a bit weak if pressured.

the glue i used i think was from a local glass cutting shop in a yellow tube just called 'glassglue' as far as i recall

69er2015-06-12 10:49:30
 

DABYX

User
Credits
109CR
Cool, cheers for the reply 69er. Good tip about reinforcing it also.
Probably wont be getting any pics for a week as I'm super busy with family and such.

Sounds like you've had some success with it so that's probably what I'll use!
 
Top