GO7 Flatline

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
I'm in no fit state to recommend anything about monitors (especially Electrohomes). Just a white line horizontally is vertical collapse and vertical transistors X401 and X402.

http://forum.arcadecontrols.com/index.php?topic=67146.0
http://www.pinrepair.com/g07/
http://www.rotheblog.com/images/arcade/misc/flowcharts/g07_flowchart.pdf

I hope you have more success with yours than I do mine! Kiss of death me!
 

Ordyne

Active member
vacBacker
Feedback
5 (100%)
Credits
1,282CR
I've yet to see a go7 with the vertical drive transistors bad, iirr there is a fusible resistor on the supply for the vert deflection, see if that is still ok.
 

forcefulfil

EDOT King
vacBacker
Feedback
17 (100%)
Credits
1,675CR
cheers Craig
i rebuilt this chassis this morning,then shelved it after the flatline

i then rebuild another only to see the same thing again!

i tested the fusible resistor and the x401 x402 all tested fine

i know the IC 501 could be dead/faulty,however to see this on both chassis seems a tad weird

im wondering if the yolk is feked?

ill try another tube/yoke tomorrow and report back
 

Ordyne

Active member
vacBacker
Feedback
5 (100%)
Credits
1,282CR
Remind me on Monday an ill see if I have any info in my notes at work, I know I've had odd ball faults in the vert deflection. If you think it's the yoke (doubtful on a GO7) check the resistance, it's good enough a test on a yoke of that spec on the vert winding.
 

tb lilley

5 Star
vacBacker
Feedback
2 (100%)
Credits
1,686CR
Same thing happened to me (flatline fault) on 2 x G07 chassis. Turned out that one of the wires connected to the yoke had come away. Soldered it back on and all was fine. Perhaps check for continuity from the pins on the yoke through to the yoke plug to PCB?
 
Top