Hantarex MTC 9000

Be77amy

Newbie
Credits
22CR
Hey, So looks like my hanty has developed a problem. Its completely missing green. the green gain on the neck board does nothing. I've tried swapping the green and red wires at the neckboard which reverses the colours (green becomes red) but still no green. I've measured on the tube socket and I'm getting ~130VDC on all 3 colours. Can I assume the worst, That the tube has gone? Anything else I can try?

On the same day my Bride of pinball developed a switch column fault too! :(
 

Be77amy

Newbie
Credits
22CR
Turning it completely one way brings in a dull green tint. Does this mean the green is OK? Adjusting the gain with the green tint on screen still does nothing
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,579CR
If you get any green it means the gun isn't dead. It could be a bit weak though. That said, you normally would see it go gradually over time, rather than instantly. It still points toward a circuit fault.
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,579CR
Good point! If the piece of plastic that connects all three levers is missing the green one could've been knocked by accident to its lowest setting.
 

Be77amy

Newbie
Credits
22CR
Are we talking about this thing?
DSC_0935.JPG
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,579CR
Nope, your chassis has the more modern contrast control, so it's unlikely to be that. The older 9000 had a bank of 3 three position switches for the contrast.
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,579CR
Could be, I've also had lack of a colour caused by a dead transistor or resistor in the relevant section of the chassis.tb20002016-11-14 23:27:15
 

Be77amy

Newbie
Credits
22CR
I've been doing some tests and so far have got. Voltage at sp205 18, sp206 15, sp207 15. At the lamp socket, 140, 170, 157 for blue, green, red. Don't know if this means anything. I also found the voltage at the emitter of tr202 to be 12 while tr203 and TR 201 are both 18. All 3 cutoff pots and gain pots seem to work. Any ideas?
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,579CR
By lamp socket I assume you mean the neck socket? Those voltages should be similar, 170v is high and indicates that it's probably not getting a green signal to it from the rgb interface/mixing section.

First thing I'd do would be to test the neckboard transistors using the diode check, ideally with them removed.
 

Be77amy

Newbie
Credits
22CR
Yeah sorry. Looks like a light bulb! Pulled the red and green transistors off and the green was testing bad. Replaced it with a spare and now my hanty is looking beautiful! Thanks for the help guys! Much appreciated!
 
Top