Hantarex MTC900E

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
I think this is the model my Goliath has in it but I checked the manual and the chasis, there is no adjustment to control the horizontal picture - as in making it wider or narrower

so the image is fine but has some quite big gaps either side

why would a manufactuer do this or am I probably missing something?!

thanks in advance
 

PaulSwan

ZZZ
Feedback
1 (100%)
Credits
1,118CR
I don't think I've ever seen a 900E with the East-West widget installed, but they were common in the earlier 900 variety. The width coil is awkwardly located towards the back right of the chassis (the front being the row of pots). It's VERY fragile - buy the proper plastic tweaker that fits the flat screw head otherwise it'll break apart if you use a screwdriver.

Note that low width can also indicate a low B+ or fault in the power regulator circuit.

This is what it looks like (after one breaks it):

DSCN3161.JPG


Paul.
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,578CR
I've never seen a 900/E width a proper width control, only the standard width coil control. I've got at least one or two 900/E with the East/West board installed. As far as I know, there was a particular model of Orion tube which used it (may well have been others). Without it you got the standard hourglass shaped image on that tube!
smiley1.gif
 

Fuzzy

Active member
vacBacker
Feedback
18 (100%)
Credits
564CR
PaulSwan said:
The width coil is awkwardly located towards the back right of the chassis (the front being the row of pots). It's VERY fragile - buy the proper plastic tweaker that fits the flat screw head otherwise it'll break apart if you use a screwdriver.

I'll second that. The plastic is very brittle and breaks very easily.
 

RaveN

Active member
vacBacker
Feedback
1 (100%)
Credits
1,325CR
If you haven't already, get something like this:
http://www.ebay.co.uk/itm/351140346938

They're designed so if you use too much pressure, they'll slip in the hole rather than force it and damage it.
Do it with the monitor warmed up as well (but preferably off, so you don't shock yourself on the yoke), by twisting it slightly back and forth until it's free.
I wrecked a couple of coils back in the day by using a screwdriver, you'll never find a new replacement adjustable coil.
 
Top