Help stuck tamper screw

PhilT

Active member
vacBacker
Credits
154CR
I have used an old hammer and chisel to cut a notch in the edge of the stuck screw, then apply some anti-clockwise force by tilting the chisel and hitting it again with a hammer. Once it moving, grab it with pliers and take it fully out. Crude but effective. and you will need a new screw...
 

Spanky

Active member
Feedback
2 (100%)
Credits
657CR
Try PZ-58 Neji-saurus GT pliers
http://www.precisehandtools.com/screw-pliers/engineer-pz-58-neji-saurus-gt-multi-purpose-pliers-with-screw-extractor-jaws

PZ-58.jpg


Spanky2016-12-10 07:03:17
 

Jase

Active member
Feedback
3 (100%)
Credits
294CR
Spanky said:

THANKYOUTHANKYOUTHANKYOU!!!!!!

I had the mother of all seized screws in my Gorf handle, soaked in WD40 and tried the dremel thing, very hard to get a decent slot in the head without cutting into the joystick handle.

The head got chewed up trying to turn the screw in the slot, so tried reverse thread drill bits. Didn't budge, but managed to drill away the head so the plastic handle could be removed.

Somehow I had less than 1mm left of the screw poking out from the metal joystick shaft, and no idea how to remove it thus stalling my Gorf CP restoration. UNTIL NOW!
smiley4.gif


I duly bought one of these pliers and with only the smallest of exposed screw to grab, this mofo did just that and removed the screw with ease!

Spanky, I am forever in your debt sir! Oh and of course I wholeheartedly recommend everyone buys one of these!
 

Spanky

Active member
Feedback
2 (100%)
Credits
657CR
Oh, good. I bought a pair a while back, but have yet to try them out. They certainly look the bollocks.
Also, that seller does a nifty set of tiny spanners you'll never find elsewhere.
 

s18dav

Active member
Feedback
1 (100%)
Credits
29CR
Update to my seized tamper screw or screws had two that would not budge tried everything
even the saurus pliers would not turn the stuck screw (does say that on the packaging not designed

for seized screws)

Solution : went to Homebase and purchased a cheap as chips angle grinder (£20)

covered the machine as best a i could and ground that stubborn little b~~~~~d till it was no more

took about 10 mins a screw, of stop and start grinding and a hell of alot of sparks (safety glasses a must)

But all done and the saurus pliers were ideal for removing the remaining screw thread after the head

and been grinded off..

So after all the grinding and bad language i finally was able to drop the control panel down and gain access to the two front control modules to see if i could stop the screen distortion..Twiddled all the pots etc but made no difference..Turned out replugging the sync wires on the chassis board fixed it..But still at least

i have access to the front modules now...

Thanks for the tips though
 
Top