High Voltage Probe?

bomjac

Active member
Feedback
3 (100%)
Credits
453CR
Megaman255 said:
That's a quality Pic!

Ever have to use the hook?
smiley5.gif

Never had to use it. It us just a final failsafe if things go bad. The suit is de signed to withstand the arc flash if it did go wrong, and tbh if you ever do contact 13.8kV then it is goodnight Vienna.
 

PaulSwan

ZZZ
Feedback
1 (100%)
Credits
1,118CR
Note about using resistors on the "screwdriver for the discharge method" - typical resistors are rated only at a few hundred volts (usually 250v) and the 20Kv will shoot through them as if they didn't exist. In theory, you'd need to use, for example, 40 x 1MOhm in series to get 500v across each resistor discharging a 20Kv load. Me, I'd thread them through heat shrink tubing as part of the cable.

The HV probe method should be a safe and reliable way :)
Paul.
 

obcd

Active member
Credits
3,830CR
Resistors with a value of 5 MOhm are normally high voltage as not many low voltage applications need such a high value. I agree they are not rated for 20Kv, but the voltage doesn't shoot trough them as described. I agree that a HV probe is the safest method, but it's expensive if you aren't repairing monitor chassis for living. The method with the resistors is better than directly shorting the HV with a screwdriver which generates a huge spark. The spark's I see with the resistors are barely noticable, and only because it's usually rather dark in the monitor compartment. Obviously, you shouldn't use 2 0805 smd resistors. Mine are 0.5 or 1Watt types with a light blue housing which indicates they can handle higher voltages.

I use my selfmade discharge probe all the time. It simply does the trick.
 

Invader

Newbie
Credits
5CR
The reason people say keep one hand in your pocket isn't exactly due to "stopping the current flowing through the heart", but really stopping the current flowing full stop. The current needs a path to flow, and if it can't flow through your body it won't. I would always recommend wearing decent trainers, or anything with a good rubber sole.

If you wear trainers with a 1cm sole, then theoretically, you would need to touch a source of 150k volts (much higher than monitors, also depends on humidity blahblah) for the current to pass through you, unless of course you do something stupid like use your other hand to hold onto the monitor frame. There's no point placing your hand in your pocket and proding a monitor, thinking you're safe whilst wearing your plimsolls or whatever metrosexual footwear is in fashion at the time.

Infact, from now on I recommend all monitor dischargers wear their girlfriends high-heels to create that extra air gap between themselves and the ground!
 
Top