HSync/VSync on Williams CPU board

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
Hi everyone

Things are getter warmer with the Defender and I now have 3 working Star Gate boards (not bad out of 4 purchased including 3 from the US!) and a working CPU board which is _almost_ showing the game correctly.

As you can see from the screen shot below, the HSync/VSync seem to be slightly out and it doesn't appear to be the monitor as we've tried all the adjustments but none of the monitor's range seems to make it work.

Anyone know (off the top of their head) whether there is a oscillator or similar on the CPU board that might be bad and not generating the correct frequencies?

Any advice mucho appreciated

Alex

IMG-20120819-00248.jpg
 

andyman

always pull away from your face
Credits
1,059CR
You have got them separated, haven't you. V on pin 5 H on pin 6 and also using the positive sync pins not the negative.
 

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
Hi Andy

Yes I'm pretty sure - just double checked and the Wells Gardner is

1 Red

2 Grn

3 Blu

4 Gnd

5 + VERT SYNC

6 + HOT SYNC

and Stargate CPU reference says

1 Red

2 Green

3 Blue

4 Ground

5 Vert. Sync

6 Horiz. Sync

so that _should_ all be correct.

BTW Your Stargate ROM board works great thanks :)
 

andyman

always pull away from your face
Credits
1,059CR
Looks right to me, clk signal comes from decoder rom 2 iirc

Take a look at the 7474 at 6C or 7486 at 4A, these are the two that deal with sync.
 

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
Good call Andy

6C is a 7474 Dual-D type Flip-Flop which I bought some of from eBay so will try that first

4A is a 7486 Quad 2-Input Ex-Or which I don't have so if anyone has some spare let me know!

Also I have other William's Decoder ROMs I can test with - on this board it's a William's Decoder 6 on the left and a William's Decoder 4 on the right

So the one I should try swapping out is the Decoder 4 one?

Thanks again!
 

chadsarcade

Lord of Vectors (tm)
Feedback
11 (100%)
Credits
443CR
Before you go delving in and changing chips, check that the sync invert track hasn't been cut or you could be feeding the monitor the wrong polarity sync!
 

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
Hey - great thoughts!

The CPU board is from my bought as working Joust set so that would make sense as per this discussion

http://www.arcadecollecting.com/info/williamsboards_sync.txt

The monitor has positive sync as well as negative sync so maybe my best bet is to unplug the two sync wires from the monitor connection and try them on the +ve ones??
 

chadsarcade

Lord of Vectors (tm)
Feedback
11 (100%)
Credits
443CR
Judder said:
The monitor has positive sync as well as negative sync so maybe my best bet is to unplug the two sync wires from the monitor connection and try them on the +ve ones??

That would do the job. Depending on what connectors you have you could either separate the 2 syncs off to a connector of their own to match your monitor inputs, or invert the jumper (it's actually a track on the PCB) and use your existing connector.
 
Top