ID pcb

Shinydaz

Active member
vacBacker
Feedback
6 (100%)
Credits
814CR
Has anyone had a similar pcb to this ? It's labelled up Omega, romident doesn't not recognise the roms.
Once I know I can make an adapter for it and test it, cheers.

IMG_20180127_33325.jpg
 

Shinydaz

Active member
vacBacker
Feedback
6 (100%)
Credits
814CR
Think ive found some info:

Added Omega (Nihon System 1986). Note: Omega code/gfx looks to be based on Gigas Mark II, given the "MarkII" graphic in the gfx roms and Gigas Mark II style continue numbers etc. PCB is marked "K.K NS6102-A" and seems to be somewhere between Gigas hardware and Free Kick hardware (3x dipswitch arrays). Supposedly an extremely limited release with ~10 PCBs produced
 

jugemscloud

Active member
Feedback
6 (100%)
Credits
69CR
i would hazard a guess that it may be sega mark 8 from the info you uncovered and looks near identical to gigas mark 2 graphically

unique pinout for gigas also has pinout for the optos for the spinners - http://www.arcade-museum.com/pinouts-game/10983.html

your pcb looks more like a legit free kick pcb though so possibly a casualty of the introduction of the jamma standard a year earlier hence the low print run, and maybe some pinout that is undocumented

jugemscloud2018-01-28 09:27:11
 

jugemscloud

Active member
Feedback
6 (100%)
Credits
69CR
shou the fount of obscure arcade knowledge and roms
smiley2.gif


yeah the gigas pinout i posted has only 18 pins you board has 22 like the schematic from shou, the major difference seems to be that the controls are on the edge connector with your pcb on pins 18 and 19, rather than being separate as with gigs, so the voltages and ac in/out at that end (bottom in the pic) used to power the optos on the spinners

jugemscloud2018-01-28 13:12:09
 
Top