Ipac programming

aeroflott

A different league
Feedback
16 (100%)
Credits
1,058CR
About to set up an ipac mini.

I have downloaded the programming tool and can see how it works.

My control panel has a joystick, a start button and six player buttons laid out as you'd expect to the right of the joystick.

My question is how would you programme the buttons for general mame use?

I need an escape button to get out of games back to the menu and want to avoid any accidental button presses mid-game for example.

Would the shift function be the answer?

Anyone with similar layouts care to share how you've set up your buttons?

Taaeroflott2015-10-24 11:49:30
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
the ipac mini has 4 extra AUX buttons fot this

the reason behind it was exactly that

Enter
Escape
Tab
Pause

(Hyperspin)

the Mini requires Winipac2 not the older version and from what i remeber its already mapped to those buttons above
 

Fantazia2

Active member
vacBacker
Feedback
13 (100%)
Credits
2,246CR
It should be already setup with the standard shift functions and not need programming, i.e. Hold down Player 1 start to enable shift and then player 1 button 1 is coin I think and Player 2 start is escape, etc.
 
Feedback
1 (100%)
Credits
9CR
Yes, it's pre-programmed so that you don't need any extra buttons, just hold down P1 start, and then:

P1 Button 1 for coin
P1 right for tab (menu)
P1 left for enter
P1 down for pause
P2 for Esc (then P1 start again to confirm if you use Mala).

I've got a 2 player panel, so I've also got P2 start + P2 button 1 set up for coin 2 where it's applicable ie on 2-player simultaneous games, you can just do that in the Mame tab menu.

What I did was use a keyboard to initially set up my games list and do the controls and everything, just because it's quicker, then once it was set up, I can use the button shortcuts to do everything in-game.
 
Top