J-Pac Speaker Help Needed Please

swisstoni

Active member
Feedback
11 (100%)
Credits
120CR
Ok just picked up a cheap set of USB powered speakers to connect to my Jpac for use in my Astro City (not the new Astro City), as you can see in the pic below on the left the red and black wire (connected to the amp) were connected to one speaker and on the right the black wire (actually was red at the top but its cut off) went to the other speaker which wires do I connect to the Jpac there are two Spkr terminals?

SPEAKERS.jpg
swisstoni2014-10-25 16:06:49
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
Speaker + and - that where on the speaker itself

so basically you have the Phono from PC coming out and connects to AMP input, the amp then process that audio and then it does to the speaker via PIN 10 and pin L of the J PAC

Pin 10 = Speaker +
Pin L - Speaker -silverfox07862014-10-25 16:02:55
 

swisstoni

Active member
Feedback
11 (100%)
Credits
120CR
Thanks for replying sorry im still a bit confused, should the black and red wire be twisted together to make it mono and connected to a speaker input (if so + or -?) and then the wire for the other speaker connected to the other speaker terminal on the Jpac?

silverfox0786 said:
Speaker + and - that where on the speaker itself

so basically you have the Phono from PC coming out and connects to AMP input, the amp then process that audio and then it does to the speaker via PIN 10 and pin L of the J PAC

Pin 10 = Speaker +
Pin L - Speaker -
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
from what I understand you should have 3 wires for a stereo speaker set

they consist of:

Right +
Left +
Ground

you would need to tie both Left and Right + and use that on Mono + pin 10 and then use the GND for Mono - Pin L
 

swisstoni

Active member
Feedback
11 (100%)
Credits
120CR
Thanks silverfox okay ive connected to the Jpac and all seemed good the amps working fine and sound is coming out of the cab speakers, it seems okay for a few minutes but as soon as the action on screen gets busy the sound starts to glitch and the light on the amp starts to flicker, possibly due to them being 2w USB speakers rather than powered?swisstoni2014-10-25 17:11:15
 

obcd

Active member
Credits
3,830CR
USB delivers 5V and should be able to deliver 500mA. You might be able to find 5V in your cabinet as well. It's just hard to know if the supply is able to deliver the extra current needed. A cheap 5V 1.2A or 2A power adapter is another solution. You find them cheap as power adapters for the raspberry pi. Most modern smartphone chargers are 5V as well, but they might be 600mA only and some (specially the cheaper ones) don't deliver a stable output power. Also be aware that pc speakers usually have ridiculous power ratings. Compare a 40W stereo amplifier to the amplifier of 40W pc speakers and you'll understand what I mean.
 
Top