J-PAC

Hitesh

Active member
Feedback
6 (100%)
Credits
207CR
Question about J-Pac requirments.

I have a Candy cabinet : Pony III 28

It is just a shell with a monitor. No cables / electrics whatsoever.

I am thinking of PC / JPAC route.

So what will I need ?

(1) jamma Loom

(2) JPAC

Anything else? Does J-PAC convert to 15khz?

Is any power needed?

Hitesh
 

chunksin

Active member
vacBacker
Feedback
21 (100%)
Credits
733CR
Hi Hitesh,

Power wise you'll need an ISO transformer to change 240v into 100v for your monitor, do you have the IEC power socket still on the cab?

You may also need a small audio amp if you want to get audio working via the jamma loom, that's only worth doing if you'll ever run a jamma board in. Otherwise you can run the audio direct from the PC.

The JPAC gets its power from the USB or PS2 cable depending on which verison you buy, it won't convert to 15Khz, you need a video card that outputs 15Khz in the first place. Most Radeon HD series cards can do it, check here for compatibility: link

Software wise you can run GroovyMame in Windows or GroovyArcade which uses a pretty much plug and play Linux installation, you can also run that off USB sticks to save on hard disks.

hope that helps - I'm sure are bits I've missed, someone will fill in the gaps!

cheers,

Rich

Chunksin2017-02-14 12:44:59
 

Hitesh

Active member
Feedback
6 (100%)
Credits
207CR
Thanks for the quick advice.

Luckily my monitor is 240v already.

Off to Ebay to order a Jamma Loom. They seem so cheap! £10 delivered.
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,087CR
Hitesh said:
Thanks for the quick advice.

Luckily my monitor is 240v already.

Off to Ebay to order a Jamma Loom. They seem so cheap! £10 delivered.

Beware! They're cheap for a reason. A lot of them around are crap.
 

AaronBoone

Active member
vacBacker
Feedback
3 (100%)
Credits
165CR
If you're solely going to use the JAMMA harness for a Jpac and not proper boards the eBay ones should be fine as the power lines don't need to be connected up as it just needs 5v (which it pulls from the USB cable as Chunksin has said). If you're using both a Jpac with the occasional board thrown in then yeah, be careful as I've just had to replace one of the eBay style looms as the +5v wires dropped off.
 
Top