Leaking Capacitors (AR3 board)

Bensonrad

STILL looking for an Outrun & Paperboy!
vacBacker
Feedback
68 (100%)
Credits
940CR
I've finally started to pull apart my spare paperboy cab and put everything into the more solid champ sprint cab. The AR3 (Audio Regulator III) looks proper manky. All of the 5 big caps have brown sludge under them all over the board.
smiley19.gif


I will get a photo up later, thought I had it with me.

Essentially does the brown sludge stuff totally wreck the PCB or is something that can be cleaned off and the Caps all replaced?
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
you would need to clean it off and check the traces as the acid in caps can rot away the copper tracing

once clean and caps removed shine a light under the PCB to get a better view of the situation
 

Bensonrad

STILL looking for an Outrun & Paperboy!
vacBacker
Feedback
68 (100%)
Credits
940CR
Cheers, there is an awful lot of it, so we'll see I guess. I do have another one in the other cab. Hopefully that one is still okay. I should probably keep my out for spare ones though, that's for sure.
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
Need a picture. This may not be gunk from the caps at all. Often with big caps they're glued down and the stuff that's used to do it is often brown
smiley36.gif
 

RaveN

Active member
vacBacker
Feedback
1 (100%)
Credits
1,325CR
Guddler's right, every AR3 i've seen has had the axial caps glued down, need a pic really.
If it is leaking caps, even if it has destroyed the board, the good news is AR3s are still quite easy to get hold of and are pretty cheap.

Caps don't tend to leak "everywhere" though do they? They dry out over years, so they're usually either blown (with a hole in the top) or leak crud from underneath, but even then it's just a small amount of dry powder.
 

Bensonrad

STILL looking for an Outrun & Paperboy!
vacBacker
Feedback
68 (100%)
Credits
940CR
Righto pics now taken and uploaded to flickr in full res glory
https://www.flickr.com/photos/59660509@N06/sets

Probably not as bad as I had first thought, I need to take it off the metal sheet to look at the back of it.
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
You can take the caps off, clean under them and check them before putting them back if you like, but to the best of my knowledge, that's glue, not capacitor leakage
smiley1.gif
 

vedat

Newbie
Credits
3CR
@Benzonrad, the PCB can
simply be cleared using alcohol. Alcohol is the best PCB cleaner in my opinion,
it has no residue and doesn’t create issues with any of your electronic
components. The PCB usually has a soldermask on its surface which is there to protect
it from such materials, this solder masks runs over all the PCB tracks so that
they are protected and don’t get corroded with time. However, if your PCB
doesn’t have a soldermask, you need to clean it urgently or it’ll eat copper
tracks up.

vedat2014-11-19 22:18:27
 
Top