Load Testing Power Supplys

Retro Guy

Newbie
Credits
5CR
Hi Sorry if this has been asked before, or maybe someone could point me in the right direction.
i would like to load test arcade power supply's after carrying out repairs, before refitting to the games pcbs.

Kind Regards
 

ColinD

Active member
Feedback
6 (86%)
Credits
1,367CR
You can use 6v and 12v lamps, high wattage resistors on a heat sink or a programable dc electronic loads (which are designed for that kind of purpose).
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,084CR
I use a high wattage resistor to put a couple of amps load on the +5v rail, as some switchers won't operate correctly without a load on that rail.
 

mdeslaur

Newbie
Credits
37CR
I use one of these from Aliexpress...it's cheap and has worked pretty good so far...

https://www.aliexpress.com/item/4001150868827.html
 
Top