Logic Probe Question

Gersk

Newbie
Credits
2CR
Hey guys!

I'm new to logic probes and trying to understand things better

I'm looking at an 74LS86 datasheet, and looking at a PCB, pins 1,2,and 3

I understand that if my pin 1 is low, and my pin 2 is high, I would expect my output pin 3 to be high, as an example, but what I'm confused about is when a pin is both low and high - I think this is called pulsing? How does that work with the truth table? I assume is means that the pin is going both low and high so if pin 1 was pulsing, and pin 2 was pulsing, then pin 3 should be pulsing? What about if pin 1 was pulsing and pin 2 was just high or low?

I hope this makes sense and sorry for the silly question but I would like to understand better
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
A pin will only ever be floating (nothing), Hi or Low and never both at the same time.

Pulsing means that the pin is switching from Low to Hi (or vice-versa). When this happens at high speed it appears on the probe that both Low and Hi are lit at the same time due to the rapid pulsing, but they are not.
 

Shinydaz

Active member
vacBacker
Feedback
6 (100%)
Credits
814CR
Im far from an expert, but I understand your question. Sometimes it doesn't matter what another pin is doing, eg If 1 or 2 is high then output will be high. 1 can be flashing like a Christmas tree, but that will have no impact on the output if 2 is high.

smiley2.gif
Shinydaz2018-01-19 17:02:10
 
Top