Lost coin door key

fullerlee

Newbie
Credits
1CR
Hi,
I have an old Raiden Jamma board with a 26" CRT in an old cabinet.

It's all working fine, but I've lost the key to the coin door. It's a round (barrel?) type lock.

Does anyone know what my best option might be to get it unlocked? I can't see anything on the lock to identify it, so finding a replacement key might be tricky.
IMG-0538.JPG


Thanks,

Lee
 

DanP

Administrator
Staff member
vacBacker
Feedback
5 (100%)
Credits
2,232CR
Can you still get in via the back door? If so you can either unscrew the lock from the other side or if you're lucky you might find a spare key attached to the coin door. Ops used to have a habit of doing that BITD...

Failing that the only option is to drill it out and replace it as Andy said.

Dan
 

jengineer

Senior Member
vacBacker
Feedback
49 (100%)
Credits
1,205CR
you won't be able to pick it, maybe try and prise it open? be careful of damaging the surrounding door, depends on the type of door?

be easy to drill with a mains drill and decent drill bits, centre punch the centre of the lock first
 

aeroflott

A different league
Feedback
16 (100%)
Credits
1,068CR
I know its very un-PC, but I've opened many a coin door by using a screwdriver and carefully jemmying the thing open at the lock until it pops open. You might bend the edge of the door slightly, but its easily bent back. Once opened, you can then disassemble the lock from the back and replace.
 

IanH

User
Credits
277CR
The best way is to use a 20mm hole saw over the lock and take the front tapered bit of the lock off, the door will pull over the lock then. Dead easy to do an only takes a few mins usually.
 

obcd

Active member
Credits
3,830CR
First, see if you can access it using the back door. You normally only have to unbold one nut to remove the metal flap that keeps the door locked.

If that isn't possible, drill it out. Be aware that it's hardened metal with lots of tiny pieces in it. You might need 2 or 3 drills as sometimes they break during the proces. You are lucky that the top of the lock is flat. Sometimes it's rounded to make drilling more difficult.
 

patloz

Active member
vacBacker
Feedback
12 (100%)
Credits
844CR

patloz

Active member
vacBacker
Feedback
12 (100%)
Credits
844CR
Not if you use it to get free chocolate and crisps from the work vending machine!

On a serious note I think i paid £40 a few years ago and it has paid me back in spades when I have lost or just cant find the keys to a machine and the damage you can cause trying to drill locks out can be considerable.

Doesn't take any skill to use either and will open most locks in less than 30 seconds.
 
Top