I am trying to make an adapter for a switcher for use in a Williams cab and the board it is going to need the following voltages at the 15 pin connector:
-5V
12V DCreg
-12V DCUnreg
+12V DCUnreg x2
GND x4
+5V x3
my switcher only has outputs for -5V, +5V, +12V and GND
so, although it is going to seem like an incredibly simple question to many here, how do i get the various voltages at the connector from the limited switcher ones?
-5V
12V DCreg
-12V DCUnreg
+12V DCUnreg x2
GND x4
+5V x3
my switcher only has outputs for -5V, +5V, +12V and GND
so, although it is going to seem like an incredibly simple question to many here, how do i get the various voltages at the connector from the limited switcher ones?