Molex Connector REMOVER

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
I'm rewiring my jamma cab and also converting a Capcom Classic to jamma so new looms are going in. but they are just wired up without MOLEX. I want to reuse my Molex connector and just buy new molex pins

what is the tool I need to remove them

so far the PC ATX molex remover is too small in diameter so I need the one that will remove these

Thanks
 

Zektor

Active member
vacBacker
Feedback
4 (100%)
Credits
312CR
http://www.precisehandtools.com/crimp-removal/engineer-pas-crimp-pin-ejector-tool-set-for-molex-jst-amp-hrs-tyco-etc

I use a set of these.
 

DaveAS

User
Credits
336CR
£73?? Fek that!

Buy a telescopic aerial for a few quid and pull it apart. Instant set of pin removal tools for various sizes.

--
Dave
 

DanP

Administrator
Staff member
vacBacker
Feedback
5 (100%)
Credits
2,232CR
I've got that £70 set but I'm pretty sure I didn't pay that. Was several years ago though. They pretty much cover everything in that set.
 
Top