Monitor Capacitor

[jonhughes]

Hi everyone,

I recently bought a cabinet and there is some wobble to the monitor image and the pots aren't adjusting very well. Otherwise, it's not too bad a picture. I've decided to do a re-cap. I've ordered all but one of the capacitors.

Is there anything special about this capacitor? I can't find a direct replacement for it. Will any 330uf 200V capacitor do or is the 200WV something a little different?

Any help greatly appreciated.

 

[tb lilley]

WV = Working Volts. i.e maximum voltage that should be applied to the capacitor.

So yeah, a 200V cap should be fine.

 

[RGP]

I believe its a standard electrolytic, not sure what the wv bit is but i've replaced with mosern ones on the occasion i've had to replace that one.

Keep the uf e same but you can put in the same or higher rated voltage.

Wait for someone else to confirm what i've just said though in case it is significant.

 

[jonhughes]

Thanks guys, I just wanted to be sure - I'm not keen on working with anything over 12V.

 

[bbz149]

That a hanty 900 as I think I got some of those spare

 

[jengineer]

That a hanty 900 as I think I got some of those spare

it looks like a 900E

 

[bbz149]

That a hanty 900 as I think I got some of those spare

it looks like a 900E

Thought so, in that case I got 2 or 3 of those Caps new if needed

 

[jonhughes]

Hi and yes, I'd prefer to perform a like for like swap. Please PM me with the cost please.