MONITOR EMERGENCY!

tb2000

Active member
Feedback
4 (100%)
Credits
3,579CR
I had to do a similar thing on a G07 a while ago as the tube was badly burnt but unfortunately all the G07 tubes I have are all burnt as well. However, I did have a tube from a Hanty with a shorted/burnt yoke, so I whipped that yoke off, put on the G07 one and job done.
smiley1.gif
Must be a thing with G07's, every single one I think i've ever seen has been burnt in!
smiley36.gif
 

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
I got the test pattern on the screen and have been trying to set the convergence for the past 3 hours. I can't get it anywhere near acceptable.

I think I have ruined this tube now. I wish I hadn't f**king bothered in the first place.

This kind of thing makes me want to give the whole lot up.

smiley18.gif
smiley7.gif
 

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
cheers chaps - going to have another stab at it now. You won't believe who came to check on my progress last night. I'll talk about it on the podcast...
 

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
Right. I give up. I can get about half the screen perfect and that's it. I'll put a kortek monitor in there for now and maybe let a tube expert have a go at it.

I hate this.
 

RGP

Meeter & Greeter
Feedback
5 (100%)
Credits
2,039CR
Sadly, convergence, purity etc can take ages to sort out.

Ensure that the yoke is fully forward against the back of the tube and orientated correctly.

The G07 manuals have good reference on sorting it out.

Test pattern can be achieved by turning test mode on, wait for the test screen to appear then flick test off then on again once and it'll advance into cross-hatch.

Can you post a good pic of where you are up to, someone might be able to help.
 

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
I really have spent too long on it. I'll bung the Kortek in it, at least I'll be able to play it.

Hopefully someone will be able to help me sort the G07 in the future?

Maybe someone in the South of the country?
smiley9.gif
 

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
Cheers Foxy, but I reckon you have to be an uber tekkie to sort out purity/convergence rings on a monitor. It's easily the hardest thing I've tried (and failed at) on an aracade machine apart from pcb repair.
smiley19.gif


I also got a nip from the neck board yesterday, just before my unexpected 'visitor' came in.
smiley18.gif
smiley24.gif
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
virtvic said:
Cheers Foxy, but I reckon you have to be an uber tekkie to sort out purity/convergence rings on a monitor.  It's easily the hardest thing I've tried (and failed at) on an aracade machine apart from pcb repair. 
smiley19.gif


I also got a nip from the neck board yesterday, just before my unexpected 'visitor' came in. 
smiley18.gif
smiley24.gif

yeah I thought as much my help would have purely been logical advice as im good at thinking outside the box

yes I got a nick from the neck board today as well lol

managed to repair my monitor though
 
Top