Monitor grounding question

MattW

Newbie
Feedback
1 (100%)
Credits
7CR
Hello,

I have a Naomi that is up and running. I purchased it in a rather rough condition with all kinds of issues, but all is going well now.

I have a question regarding the CRT, and please excuse me if I get the terminology here wrong as I'm new to all of this.

Looking at the front of the cab, with the plastic surround off, there is a ground cable attached to the right leg, and just hanging next to the CRT metal casing. It's not attached to anything. At a guess I should unscrew one of the screws holding the monitor into the metal casing and put it in there, but I wanted to check because I understand doing anything silly on a CRT is dangerous, and I'm not sure attaching the CRT to the rest of the cab this way is the correct thing to do.

When I got the cab, the monitor wasn't using the plastic washers so it was "grounded" to the rest of the cab anyway.

Thanks in advance for the advice, and sorry if this is daft question. Better to ask than take risks :)
 

thechop

Model 3 Man
Feedback
15 (94%)
Credits
388CR
It's normally attached to the monitor frame, there's a screw hole near the bottom right corner, to the left of the monitor mounting hole.
 

thechop

Model 3 Man
Feedback
15 (94%)
Credits
388CR
Yeah there's one on each corner, just checked in case the monitor frame being'upside down' made a difference but there one about 3inches away from each monitor mounting hole on the frame, mines attached where you said on the monitor mount as if I recall I always forget this one when removing a monitor and nearly give myself a hernia, if it's on the mount your guaranteed you've disconnected it, still not sure if it makes any diff being there tho.
 

MattW

Newbie
Feedback
1 (100%)
Credits
7CR
If I can avoid removing the monitor that would be great :)

I assume putting it on the monitor mounting posts won't ground is, as the monitor is sat on the plastic washers on the posts.
MattW2014-12-31 12:08:32
 

RGP

Meeter & Greeter
Feedback
5 (100%)
Credits
2,039CR
The frame on a cab should be earthed, it's in case anything live strays to anything metal.

While the monitor might be sitting on plastic, it's ground terminated in other ways (or at least should be).

I think the monitors I. This type of cab are running off mains voltage anyway so there should be an earth elsewhere on the monitor frame to the mains earth.

He extra strap is belt and braces to ensure there are multiple earth paths.

It's a bit like ring mains electric, you don't have to run back to your live/neutral making a loop but you should so that one wire becoming disconnected doesn't stop the circuit from working either side of it.

Anyway, attach it if you can.
 

MattW

Newbie
Feedback
1 (100%)
Credits
7CR
This is where I've put the ground on the monitor:

20141231_131412.jpg


For reference and double checking, this is a photo inside the base. I've spliced the single input, so it goes to both the transformer and PC PSU. The little yellow zip ties you see holding the power cables clear at the back have now been replaced and heatshrinked :)

20141013_171400.jpg
 

MattW

Newbie
Feedback
1 (100%)
Credits
7CR
Thanks. I imagine it's the best place to put it, but knowing very little about electrics I'd rather have asked than done something silly :)
 
Top