Monitor Horizontal not going down fully

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
I have a MTC 9000 monitor and The Horizontal Width does not adjust down fully using the remote board

The Width coil has glue on it so cant be adjusted

I hear a faint hiss/buzz from the monitor when its on other wise picture is great

could the remedy be a new flyback or just a cap kit or do I need to change the width coil on it

Thanks
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
I would say 2 or more I can adjust the horizontal position and when I centre it the picture is overscaned horizontally by about 2-3cm either side silverfox07862014-11-30 14:26:48
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
gunblade said:
there is a cap in the flyback area that causes that issue,think it c42

thanks for confirming this

I just saw a thread on J+ by hektik that mentions the same thing

I have brought a full cab kit of 24 caps so will go ahead and do them all

one last Q.

C42 is a Plastic package Electrolytic cap, can I use a metalized Electrolytic cap to replace itsilverfox07862014-11-30 16:21:37
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
Thanks mate I thought it would be ok

took the monitor chassis out to look at it and its had work done in the past but a very very past as it was caked in soot

I gave it a wash and am so glad I did, its almost impossible to see but the hissing is explained

the flyback is the original flyback dated 1989 and has almost invisible cracking so a flyback change also needed

I have a spare parts chassis that has a replaced flyback from about 10 years ago by craig so I will use that one
 
Top